added tests for scheduler, use macro ARRAY_LENGTH also in tests, removed ...

unused function incl. tests, run rules tests before interrupts are
initialized to avoid interference

fixed tests, check if airgate in each relevant rule individually

simplified scheduler, open airgate on warmstart

use macro ARRAY_LENGTH thoughout the code

added some documentation to the task scheduler, close airgate on heater ...

timeout

added simple task scheduler, many improvements and fixes

airgate control basically working

initial stepper motor implementation for setting the airgate position

fixed declaration in strings.h, include strings.h, fixed tests

renamed some variables, fixed and added some comments

simplified and more stable way to determine the state of the fire

keep 18 previous temperature values of the last 3 minutes to compare ...

against the current temperature every 10 seconds instead of comparing
only every 3 minutes, some other changes

apply rule warmStart also when fire is burning

enabled rule "tooRich" again since in can be useful, but with higher ...

thresholds

disabled rule "tooRich" because it does not seem to be a good idea to ...

give more air when the combustion is rich

removed dir warm_start and added rule warmStart instead, tweaked and ...

simplified rules again, adjusted and added tests

further improved rules, adjusted tests, added test

some more tweaking of rules and adjusted some tests

fixed/tweaked again the rules

adjusted rules: wait longer for oxygen sensor to be heated up and give ...

it more time to heat up, time out the sensor heater after 15 mins if
there does not seem to be a fire, switch the heater on if it is off and
not faulted and it seems obvious there is a fire burning, decreased the
min. temp the oven is expected to reach to 700°C, consider the fire
burning if it either reached that min. temperature or if lambda is below
2.

commented constants in rules

added fire dir "burning" and "warm_start", initial impl. of rules for ...

warm start, use constants in rules, added assertNull and assertNotNull

initialize prev measurements with current measurements, updated TODO

allow switching to 8 MHz, use bit shift instead of division to calculate ...

time, poll button every 32 ms instead of 16 ms, some other small
improvements, adjusted tests

use enums instead of constants, rename "heating" to "heater"

moved button, beeper and heater pin settings to pins.h, maintain airgate ...

position in rules, added "tooLean" rule, show fire "direction" together
with current measurements

adding tests + some minor cleanup and improvements

added/improved/fixed some tests, some related small fixes and ...

improvements

don't measure, update and display lambda when heating is not ready since ...

these measurements are useless

added menu position showing the time since last start/reset