no need to wait for USART data to be sent with SLEEP_MODE_IDLE instead ...

of SLEEP_MODE_ADC

added todo

moved ADC and LCD pin constants to pins.h

Create README.md

- added comments ...

- fixed splitting command string into fields
- improved handling of display updates
- moved MIN/MAX macros to integers.h

uncomment assert

moved ISRs to module interrupts

Another Jenkins test

Undo try tests in Jenkins without testSetupSleepMode()

Added comment, adjusted existing tests

- Use SLEEP_MODE_IDLE instead of SLEEP_MODE_ADC (and ...

loop_until_bit_is_clear(ADCSRA, ADSC)) since it will not corrupt USART
RX/TX data and click the beep
- Use shorter commands to for less typing and memory
- Command to enable/disable logging
- Use atoi() instead of strtol() since it requires less flash and should
be sufficient here

- Set and cancel alerts ...

- Display text
- Receive USART data
- Simulation by sending measurement values via USART
- Added some commands like enabling and disabling simulation
- Some refactoring and renaming of functions
- Comments missing
- Tests missing

- Include min lambda value in max measurements and vice versa ...

- Added timer1 toggling PB1 (beeper) at 1.95 kHz
- Added initial alert module

- Other symbols for display options ...

- Measure and display only every second but update the display
additionally when the menu button was pushed

Corrected wrong calculation

Refactored to use a timer interrupt polling the button instead of the ...

button triggering an interrupt, replaced the delay by a timer and
separated logging from updating the display

Use defined ADC pins in other test as well, some cleanup

Moved ADC pin defines to adc.h and use them in adc.c (DIDR) and in the ...

tests as well

Typo in comment

- Put ADC pins in sensors.h ...

- Added comments for pin assignment in "official" diagram

Added a simple "menu" (display options that show min and max ...

measurements since last start/reset) accessible through a pushbutton
triggering an PICINT interrupt. Added two modules "interrupts" and
"display", refactored code and added some tests.

Do not divide the oxygen sensor voltage by 11 before looking up the ...

lambda value but multiply the voltages in the lookup table by 11

Added TODO

- Smarter way of calculating moving average and avoiding rounding errors ...

- Use unsigned integers for voltages from ADC since they can never be
negative

Updated TODO

Formatting

- Added lambda range "Okay" ...

- Round lambda value shown on display to precision 1
- Log lambda value x1000 (max. precision)
- Remove logging of realtime measurements
- Added tests, updated some comments

Again the other USB port...

Use macros bit_is_set() and assertTrue()

Pins not ports